Skip to main content
NetApp Knowledge Base

What are the recommended settings for Solaris 10 with Ontap?

  1. Last updated
  2. Save as PDF
Views:
33
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

  • Ontap 9
  • Solaris 10

Answer

The setting remains same for Solaris 10 as compared to Solaris 11.x.

Additional Information

WARNING

Note: Post HUK installation, Host reboot is required to ensure that the HBA parameters are set accordingly.
 
  • To complete the installation, you must configure the host parameters for your environment (Oracle Solaris I/O Multipathing or MPxIO in this case) by using the host_config command.
  • The host_config command has the following format:
/opt/NTAP/SANToolkit/bin/host_config ←setup> ←protocol fcp|iscsi|mixed> ←multipath mpxio|dmp| non> [-noalua] [-mcc 60|90|120]
 
  • With regards to host_config setup command for FC protocol, /opt/NTAP/SANToolkit/bin/host_config -setup -protocol fcp -multipath mpxio is the command that needs to be run on the host .
  • Other than that no other specific parameters are required.
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.