Skip to main content
NetApp Knowledge Base

Openshift POD reports failed path

  1. Last updated
  2. Save as PDF
Views:
45
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

  • Ontap 9
  • RHEL OS running in a OpenShift Pod

Issue

  • LUN was provisioned by OpenStack Cinder driver.
  • The lun and volume both are online.
  • The lun is mapped and the LIF is up/up
  • Below multipath status is seen on the RHEL Host

3600a098038314977385d55755767xx 47dm-0 NETAPP,LUN C-Mode
size=200Gfeatures='2 pg_init_retries 50' hwhandler='1 alua' wp=rw
`-+-policy='service-time 0' prio=0 status=enabled
 |- 3:0:0:0   sdb  8:16   failed faulty running
 `- 7:0:0:0   sdc  8:32   failed faulty running

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.