Skip to main content
NetApp Knowledge Base

FLI disk shows broken post migration

Views:
36
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
san
Last Updated:

Applies to

  • Offline FLI
  • Ontap 9.x
  • Thirdparty storage 

Issue

  • FLI disk shows as broken on Ontap CLI post offline FLI migration.
  • All the initiators are removed from the zoning on switch end. 

AFF-C400::> storage errors show
Disk: HPE-1.14
UID: 600C0FF0:003B55EA:6FE71563:01000000:00000000:00000000:00000000:00000000:00000000:00000000
--------------------
HPE-1.14 (600c0ff0003bxxyyxyxyxyy301000000): This array LUN is an unknown device.
HPE-1.14 (600c0ff0003b5xxyyxyxyxyy301000000): This array LUN is only available on one path. Proper configuration requires two paths.
This disk is in a failed state with the outage reason "init failed". The Disk needs to be removed and replaced.

  • As a troubleshooting step Ontap FC Initiator ports can be made offline to make sure there is no active connection to the third party storage.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.