Skip to main content
NetApp Knowledge Base

FC Port Shows “portdown” After Mode Change

  1. Last updated
  2. Save as PDF
Views:
7
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

ONTAP 9

Issue

  • After changing the mode of FC ports 3c/3d from “initiator” to “target”, port 3c reports status “portdown” and port 3d reports “uncabled”. The change does not take effect.
  • The following EMS log messages are observed:
[Cluster-01:svc_queue_thread:ucm.type.changed:info]: FC-4 type has changed to target on adapter 3c. Reboot the controller for the changes to take effect.
[Cluster-01:svc_queue_thread:ucm.type.changed:info]: FC-4 type has changed to target on adapter 3d. Reboot the controller for the changes to take effect.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.