Skip to main content
NetApp Knowledge Base

Excessive port errors and FC connectivity issues

  1. Last updated
  2. Save as PDF
Views:
263
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
san
Last Updated:

Applies to

Brocade

Issue

  • Increasing port error counters within a few hours with porterrshow
  • All ports show "Fault" and "No_Sync" state  with switchshow
  • After switch reboot everything is working for sometime
  • No changes for example firmware updates to end devices
  • In errdump -a  we see CHASSIS, ERROR, Brocade300, S0,Px: Port Fault: Hard 0 against all ports

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.