Skip to main content
NetApp Knowledge Base

CONTAP-130019: WWPN's are identical on both heads of a single_image cluster

Views:
11
Visibility:
Customer
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:
4/24/2025, 12:59:54 PM

Issue

A situation of matching wwpn's on both controllers of an HA-pair can arise if a storage controller and its disks were at some point disconnected from its original partner node and then connected to another partner node. This typically never is done in practice but can occur. The problem occurs when using FCP cfmode single_image mode or when switching to single_image mode.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.