Skip to main content
NetApp Knowledge Base

ONTAP API returns 200 OK even with an invalid value

Views:
160
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

ONTAP API

Issue

The following command fails due to invaild IP address of clientmatches as below.

::> vserver export-policy rule remove-clientmatches -vserver Test009 -policyname luxin -ruleindex 10000 -clientmatches 1.1.1.1

Warning: Not removing any strings from the clientmatch field for ruleindex 10000 in export policy "luxin", vserver "Test009". None of the match strings were found in the clientmatch list.

 
However, using REST API as below gets 200 OK status code.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  • Was this article helpful?