Skip to main content
NetApp Knowledge Base

ONTAP - How to re-enable a disabled SAS port

  1. Last updated
  2. Save as PDF
Views:
2,179
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

ONTAP 9

Description

  • This procedure enables a SAS port that has been disabled
  • The port may have been disabled during troubleshooting to stop port flapping
  • The disabled port will carry over across reboots and SAS card swaps
  • The port will show offline both at the Cluster prompt and in Maintenance Mode


 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.