Skip to main content
NetApp Knowledge Base

FCP target port down after SFP and cable replacement on AFF Hardware

  1. Last updated
  2. Save as PDF
Views:
81
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

  • ONTAP
  • AFF
  • FCP

Issue

  • No power levels on TX or RX values for FCP port on the same ASIC
  • SFP replaced on both ports but ports still show disconnected
  • SFP and cable replaced at switch did not fix connectivity
  • Moved connection to new switch port and link still did showed disconnected at FCP ports on AFF Hardware.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.