Skip to main content
NetApp Knowledge Base

Autonomous Ransomware Protection stuck with disable-in-progress

  1. Last updated
  2. Save as PDF
Views:
138
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
CORE
Last Updated:

Applies to

  • ONTAP 9.14.1 and 9.15.1
  • Autonomous Ransomware Protection (ARP)

Issue

  • Cannot disable ARP on volume vis ONTAP System Manager.
  • Volume has been stuck in the disable-in-progress state for an extended period of time:
::> security anti-ransomware volume show -state disable-in-progress
Vserver               Volume                               State                                   Dry Run Start Time
----------               ----------------                    ----------------                    ------------------
svm1   vol1         disable-in-progress
  • Attempting to enable ARP results in the following error:
::> volume modify -vserver svm1 -volume vol1 -anti-ransomware-state enabled
 
Error: command failed: Disabling of anti-ransomware for volume "vol1"
in Vserver "svm1" is in progress.  Wait a few minutes, and try the
operation again.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.