Skip to main content
NetApp Knowledge Base

MetroCluster subsystem reports degraded after ONTAP upgrade

  1. Last updated
  2. Save as PDF
Views:
3
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
metrocluster
Last Updated:

Applies to

  • ONTAP 9
  • MetroCluster

Issue

  • MetroCluster subsystem shows 'degraded' status in system health output after ONTAP upgrade
::> system health subsystem show

Subsystem Health
-----------------------------------
MetroCluster degraded

::> metrocluster check show
Component Result
----------------------------
nodes warning
lifs ok
config-replication ok
aggregates ok
clusters ok
connections not-applicable
volumes ok
  • Additionally, metrocluster check nodes output showed:
    warning:Automatic switchover feature is not enabled.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.