Skip to main content
NetApp Knowledge Base

MetroCluster connection connect fails when using compliant switches

  1. Last updated
    Jul 8, 2020
  2. Save as PDF
Views:
479
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:
7/8/2020, 10:38:51 AM

Applies to

  • MetroCluster IP
  • ONTAP 9
  • Compliant Switches
  • 25G MetroCluster IP ports

Issue

After configuring the MetroCluster compliant switches and attempting to run metrocluster configuration-settings connection connect, the command fails with errors:

ClusterA::> metrocluster configuration-settings show-status
Cluster                    Node               Configuration Settings Status
-------------------------- ------------------ ---------------------------------
ClusterA
                           ClusterA-01        connection error
              Error: Did not receive a "ping" response using the network
              addresses "10.0.1.1" and "10.0.1.2" on node "ClusterA-01" in
              cluster "ClusterA".
                           ClusterA-02        connection error
              Error: Did not receive a "ping" response using the network
              addresses "10.0.1.2" and "10.0.1.1" on node "ClusterA-02" in
              cluster "ClusterA".

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.