Skip to main content
NetApp Knowledge Base

When executing "snapmirror update" and "snapmirror initialize" commands, no response is returned

  1. Last updated
  2. Save as PDF
Views:
56
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror

Issue

  • When executing the snapmirror update and snapmirror initialize commands, no response is returned, and the prompt does not reappear, which prevents any further operations.
  • Even after disconnecting and reconnecting via SSH, while other commands (such asvolume show or snapmirror show ) function normally, snapmirror update and snapmirror initialize commands still yield no response.
  • Normally, ONTAP's audit log will immediately record the command execution transition from Pending to Success . However, in this case, snapmirror update command only has a Pending entry with no corresponding Success log, and there is no audit log entry for the snapmirror initialize command.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.