Skip to main content
NetApp Knowledge Base

Unable to delete vserver peer

  1. Last updated
  2. Save as PDF
Views:
447
Visibility:
Public
Votes:
1
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9.10
  • SnapMirror

Issue

  • After issuing vserver peer delete command the prompt is returned with no error, however the vserver peer show command still shows the peer enabled
  • EMS Logs report job failed:
    Job "'vserver peer delete'" [id 617] (Deleting a Vserver peer relationship between <vserver> and <vserver>) completed unsuccessfully: Remote cluster operation failed. Run cluster show on the remote cluster to verify that all nodes are healthy, wait a few minutes, and then try the command again. (1258298).

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.