Skip to main content
NetApp Knowledge Base

SnapMirror update fails with error "must be a data-protection volume"

Views:
1,504
Visibility:
Public
Votes:
2
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror

Issue

When issuing a snapmirror update command an error is generated

Fri Jan 30 xx:xx:xx EDT 2023 ManualUpdate[Jan 30 19:25:50]:xxxxxxxx-xxxx-xxxx-xxxx-xxxxxxxxxxxx action=End source=vs0:v2_src destination=vs1:v2_dst status=Failure message=Destination vs1:v2_dst must be a data-protection volume.

Note: smc.snapmir.update.fail is reported as an EMS event

smc.snapmir.update.fail:Snapmirror update from source volume 'vs0:v2_src' to destination volume 'vs1:v2_dst' failed with error 'Destination vs1:v2_dst must be a data-protection volume.'. Relationship UUID 'xxxxxxxx-xxxx-xxxx-xxxx-xxxxxxxxxxxx'.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.