Skip to main content
NetApp Knowledge Base

SVM DR migration to MCC failure

  1. Last updated
  2. Save as PDF
Views:
82
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • Metro Cluster (MCC)
  • SVM DR

Issue

Migrating an SVM into a MetroCluster solution using SnapMirror asynchronous replication fails with error:
Failed to apply the source Vserver configuration. Reason: No eligible aggregate to place the volume. Make sure that a non-root, non-taken-over, VGE supporting aggregate with enough free space exists at the destination cluster. If aggr-list is configured for the Vserver make sure that an eligible aggregate is present in that list. Verify that the number of volumes is less than the supported maximum on the nodes in the destination cluster.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.