Skip to main content
NetApp Knowledge Base

Why after initializing SVM-DR destination SVM LIF’s are shown as Admin UP/Operational DOWN?

  1. Last updated
  2. Save as PDF
Views:
374
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
DP
Last Updated:

Applies to

  • ONTAP
  • SVM-DR

Answer

This is expected behavior when the initialization of the SVM-DR finishes.

Additional Information

  • The operational status of data LIFs is determined by the status of the SVM with which the data LIFs are associated. When the SVM is stopped, the operational status of the LIF changes to down. When the SVM is started again, the operational status changes to up.
  • The status of the destination SVM is stopped.
  • Displaying LIF information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.