Skip to main content
NetApp Knowledge Base

FlexGroup SnapMirror stuck in quiescing state

  1. Last updated
  2. Save as PDF
Views:
296
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9.7
  • FlexGroup volumes
  • SnapMirror

Issue

  • The snapmirror quiesce command was executed to enable the expansion of a FlexGroup volume that serves as the destination in a SnapMirror relationship.
  • The operation remained in the quiescing state with no change to quiesced state
  • Ran the command below in diag mode, the status of some of the constituents relationships it transferring
::*> snapmirror show -destination-path svm_dst:fg_dst -expand

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.