Skip to main content
NetApp Knowledge Base

Cluster peer creation fails with "RPC: Remote system error"

  1. Last updated
  2. Save as PDF
Views:
13,715
Visibility:
Public
Votes:
3
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

ONTAP 9 and later

Issue

Even though a network ping test passes, the creation of a cluster peer relationship still fails with a few possible messages:

cluster2::> cluster peer create -peer-addrs 10.64.23.34,10.64.23.35
Error: command failed: Using peer-address 10.64.23.34: An introductory RPC to the peer address "10.64.23.34" 
failed to connect: RPC: Remote system error - Operation timed out.
Verify that the peer address is correct and try again.

Error: command failed: Using peer-address 10.64.23.34: An introductory RPC to the peer address "10.64.23.34" 
failed to connect: RPC: Remote system error [from mgwd on node "node_1" (VSID: -1) to xcintro at 10.64.23.34].
Verify that the peer address is correct, and then try the operation again.

 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.