Skip to main content
NetApp Knowledge Base

SVM DR fails to update due to too many SnapMirror snapshots on destination

  1. Last updated
  2. Save as PDF
Views:
158
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
DP
Last Updated:

Applies to

  • ONTAP 9.x
  • SVM DR

Issue

  • SVM DR update fails to transfer snapshots:

Thu Nov 24 11:00:26 CET 2022 ManualUpdate[Nov 24 11:00:21]:UUID Operation-Uuid=ID Group=vserver Operation-Cookie=123 action=End source=SVM:vol1 destination=SVM-DR:vol1 status=Failure message=Transfer did not start because the number of Snapshot copies on destination volume "SVM-DR:vol1" will exceed the maximum supported count of 1019

  • When checking the destination volume we can see the volume is full of vserverdr.**** snapshots 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.