Skip to main content
NetApp Knowledge Base

Can vol move be used to move a non-SnapLock volume  to a SnapLock aggregate

  1. Last updated
  2. Save as PDF
Views:
709
Visibility:
Public
Votes:
0
Category:
snaplock
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • ONTAP 9.8 and later

Answer

  • No, it is not possible to use the vol move command to move a non-SnapLock volume to a SnapLock aggregate in ONTAP 9.7 or earlier
  • When vol move is used to move a non-SnapLock volume to a SnapLock aggregate, on ONTAP 9.7 or earlier, the operation fails with the error:
Unable to move volume [non-SnapLock volume name] in Vserver [vserver name] to aggregate [snaplock aggregate]. Moving a volume to a SnapLock aggregate is not supported.

Additional Information

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.