Skip to main content
NetApp Knowledge Base

Cannot delete LUN after aborted or failed NDMP restore job

  1. Last updated
  2. Save as PDF
Views:
62
Visibility:
Public
Votes:
6
Category:
ndmp
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • NDMP

Issue

  • After an NDMP restore job was aborted or failed during the files phase, the LUN can't be deleted.
  • Error message:

LUN "/vol/vol_1/LUN_1.lun" in SVM "SVM_1" is the target of an ongoing restore operation and is inaccessible to I/O and management.  Wait until the restore is complete, and then try the command again.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.