Skip to main content
NetApp Knowledge Base

SnapCenter Plug in for VMware vSphere Disconnected After IP Change

  1. Last updated
  2. Save as PDF
Views:
26
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
not set
Last Updated:

Applies to

  • * SnapCenter Plug-in for VMware vSphere (SCV) 6.0.1
  • * SnapCenter Server 6.1.0.5101
  • * NetApp AFF-C30 (ONTAP 9.16.1P9)
  • * Environments where SCV appliance IP address has changed

Issue

After changing the IP address of the SnapCenter Plug-in for VMware vSphere
appliance (from 10.140.4.95 to 10.115.4.95), the plug-in became disconnected
from the SnapCenter Server.
Error message observed:

host down_x000D_

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.