Skip to main content
NetApp Knowledge Base

Why Aggregate Latency graph in UM, shows constantly higher latency for one aggregate?

  1. Last updated
    Mar 16, 2023
  2. Save as PDF
Views:
643
Visibility:
Public
Votes:
0
Category:
active-iq-unified-manager
Specialty:
om
Last Updated:
3/16/2023, 5:20:07 AM

 

Applies to

ActiveIQ Unified Manager 9.7P1 (UM) and Later

Answer

  • UM calculates the average weighted latency of each disk that is part of the aggregate, based on a few counters, such as Reads, writes and CP reads.
  • UM always presents the highest average weighted latency of all the disks, as the aggregate latency
  • Even if only one disk has higher latency, the total aggregate latency graph is affected.

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.