Skip to main content
NetApp Knowledge Base

After redeploying ONTAP Select cluster, AIQUM cannot monitor the new cluster

  1. Last updated
  2. Save as PDF
Views:
61
Visibility:
Public
Votes:
0
Category:
active-iq-unified-manager
Specialty:
om
Last Updated:

Applies to

  • Active IQ Unified Manager
  • ONTAP Select
  • Redeploying a new ONTAP Select cluster using the same IP address as the oid one without deleting it from AIQUM

Issue

  • After redeploying a new ONTAP Select cluster,  AIQUM shows Health Poll for the cluster as Failed.
  • Edit Cluster fails with error:

Cannot update address of datasource <CLUSTER> to point to a new or another existing cluster address.

  • Remove Cluster shows <CLUSTER> was deleted, but Deletion for the cluster is displayed as In Progress or Failed and it is not being deleted.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.