Skip to main content
NetApp Knowledge Base

Search

  • Filter results by:
    • View attachments
    Searching in
    About 1 results
    • https://kb.netapp.com/on-prem/ontap/OHW/OHW-KBs/Mapping_Ports_step_during_headswap_fails_with_Error__Cannot_run_this_command_because_the_system_is_not_fully_initialized
      Applies to ONTAP 9 Issue During the 'Mapping Ports' step in the headswap guide, commands fail with Error: Cannot run this command because the system is not fully initialized. Wait a few minutes, and t...Applies to ONTAP 9 Issue During the 'Mapping Ports' step in the headswap guide, commands fail with Error: Cannot run this command because the system is not fully initialized. Wait a few minutes, and then try the command again. RDB applications will also show offline during this step. This can be verified with the diagnostic command cluster ring show