Applies to NetApp BlueXP NetApp Cloud Volumes ONTAP (CVO) ONTAP 9 Issue When mapping volume created using Add Volume in Working Environment to network drive in Windows client, it appears to be 5% smal...Applies to NetApp BlueXP NetApp Cloud Volumes ONTAP (CVO) ONTAP 9 Issue When mapping volume created using Add Volume in Working Environment to network drive in Windows client, it appears to be 5% smaller. Example: Volume created with 1TiB appears as 972GB on Windows. (1024 x 0.95 = 972.8)
Volume growth rate is calculated based on monthly averages and then used to predict a date-when-full based on capacity values from up to a year in the past. For this reason it is possible for the proj...Volume growth rate is calculated based on monthly averages and then used to predict a date-when-full based on capacity values from up to a year in the past. For this reason it is possible for the projected date-when-full to be in the past, even if space was recently freed up on the volume. As a result the volume landing page may display 0 days until full even though it is not yet full.
Applies to Active IQ Digital Advisor (AIQDA) Issue Storage efficiency report missing in Active IQ Digital Advisor Capacity and Efficiency tab ASUP option -remove-private-data is enabled on Clusters
Applies to Active IQ Unified Manager (UM)9.6 + OnCommand Unified Manager (UM) 9.5 and below All OS platforms Issue When viewing the capacity graph for a volume or aggregate in UM, the current and tren...Applies to Active IQ Unified Manager (UM)9.6 + OnCommand Unified Manager (UM) 9.5 and below All OS platforms Issue When viewing the capacity graph for a volume or aggregate in UM, the current and trending capacity lines are missing UM GUI shows 'Insufficient Historical Data'
Applies to ONTAP Deploy 9.7 and earlier ONTAP Select HW RAID VMWare ESXi VMWare vCenter Issue Differences seen reported by ONTAP Deploy when trying to + capacity to any node in an HA Pair. In the foll...Applies to ONTAP Deploy 9.7 and earlier ONTAP Select HW RAID VMWare ESXi VMWare vCenter Issue Differences seen reported by ONTAP Deploy when trying to + capacity to any node in an HA Pair. In the following example, the cluster uses 4TB from its capacity pool (which is the correct sum), but when trying to add more, we only see 2TB "realized" by Deploy as Current Capacity:
Applies to NetApp Cloud Backup (formerly AltaVault) Issue AltaVault will reject write attempts on the frontend to all shares when the utilization exceeds 110% of the licensed cloud capacity There will...Applies to NetApp Cloud Backup (formerly AltaVault) Issue AltaVault will reject write attempts on the frontend to all shares when the utilization exceeds 110% of the licensed cloud capacity There will be the following messages logged when maximum licensed capacity is reached : Jan 7 00:10:41 localhost rfsd[11255]: [mgmt_connection.ERR] (20410) Licensed capacity exceeded, raising over_capacity alarm
Applies to SolidFire Element OS 12.3.2 Answer Yes. The drives belonging to the down node will be temporarily unavailable If a node is synced out of the cluster, the total cluster capacity will also be...Applies to SolidFire Element OS 12.3.2 Answer Yes. The drives belonging to the down node will be temporarily unavailable If a node is synced out of the cluster, the total cluster capacity will also be reduced Additional Information How to use Maintenance Mode in NetApp Element software
Applies to ONTAP 9 Answer The command volume show reports what is on both the performance and capacity tiers You can see how the storage is distributed between the performance tier and the capacity ti...Applies to ONTAP 9 Answer The command volume show reports what is on both the performance and capacity tiers You can see how the storage is distributed between the performance tier and the capacity tier using vol status -f on the node shell Additional Information
