Applies to SnapCenter server 4.1 and later Issue When attempting to add an untrusted domain to SnapCenter, it is not possible to add the correct IP address to the domain controller. When Resolve is cl...Applies to SnapCenter server 4.1 and later Issue When attempting to add an untrusted domain to SnapCenter, it is not possible to add the correct IP address to the domain controller. When Resolve is clicked in the Add Domain, it resolves to an incorrect IP address, or you need to redirect the domain traffic from SnapCenter to a different domain controller.
Applies to NetApp HCI clusters which are reporting to ActiveIQ Description If an HCI cluster is reporting to ActiveIQ--and assuming it is reporting both the storage and vCenter API information--the ma...Applies to NetApp HCI clusters which are reporting to ActiveIQ Description If an HCI cluster is reporting to ActiveIQ--and assuming it is reporting both the storage and vCenter API information--the management node's (mNode) IP address can be derived from one of the following steps below:
Service Processor (SP) Node reports the following error in event logs: [NODE1: servprocd: sp.dhcp.failure:error]: Service Processor cannot obtain network configuration using DHCP. DHCP is enabled but ...Service Processor (SP) Node reports the following error in event logs: [NODE1: servprocd: sp.dhcp.failure:error]: Service Processor cannot obtain network configuration using DHCP. DHCP is enabled but no IP address is configured on the SP: ::> run -node node1 -command sysconfig -a Service Processor Status: Online Mgmt MAC Address: 00:XX:XX:XX:XX:38 Ethernet Link: up, full duplex, auto-neg complete Using DHCP: yes IPv4 configuration: IP Address: unknown IPv6 configuration: Disabled
