Skip to main content
NetApp Knowledge Base

Search

  • Filter results by:
    • View attachments
    Searching in
    About 5 results
    • '-E- Burning FS3 image failed' error when upgrading Element cluster
      https://kb.netapp.com/Legacy/NetApp_HCI/OS/E_Burning_FS3_image_failed_error_when_upgrading_Element_cluster
      Applies to NetApp Element software NetApp HCI Issue Error during Element upgrade when flashing NIC firmware: "E- Burning FS3 image failed: Flash write failed: Flash erase of address 0x400000 failed: M...Applies to NetApp Element software NetApp HCI Issue Error during Element upgrade when flashing NIC firmware: "E- Burning FS3 image failed: Flash write failed: Flash erase of address 0x400000 failed: MFE_REG_ACCESS_BAD_PARAM" Full output in Additional Information.
    • Potential issues and workarounds when running storage upgrades using NetApp Hybrid Cloud Control
      https://kb.netapp.com/Legacy/NetApp_HCI/OS/Potential_issues_and_workarounds_when_running_storage_upgrades_using_NetApp_Hybrid_Cloud_Control
      During storage upgrades using NetApp Hybrid Cloud Control, you might encounter the following scenarios: The session times out after two hours into the upgrade, and you are logged out of the NetApp Hyb...During storage upgrades using NetApp Hybrid Cloud Control, you might encounter the following scenarios: The session times out after two hours into the upgrade, and you are logged out of the NetApp Hybrid Cloud Control UI You are logged out of NetApp Hybrid Cloud Control towards the end of the upgrade, and cannot log back in During a storage upgrade, users might see an error page if NetApp Hybrid Cloud Control is refreshed in the finishing stages of the upgrade
    • Datastores disconnect while last node is being upgraded
      https://kb.netapp.com/on-prem/solidfire/Element_OS_Kbs/Datastores_disconnect_while_last_node_is_being_upgraded
      Applies to NetApp Element Software SolidFire NetApp HCI Management Services 2.17 and below Description During an upgrade, datastores are disconnected on ESXi hosts. This happens specifically on cluste...Applies to NetApp Element Software SolidFire NetApp HCI Management Services 2.17 and below Description During an upgrade, datastores are disconnected on ESXi hosts. This happens specifically on clusters with Management Services at 2.17 or below. This is fixed in Management Services 2.18.
    • SolidFire and HCI upgrades unable to start due to upgrade package upload error
      https://kb.netapp.com/on-prem/solidfire/Element_OS_Kbs/SolidFire_and_HCI_upgrades_unable_to_start_due_to_upgrade_package_upload_error
      Upload of the upgrade package fails thus preventing SolidFire and HCI upgrades to start.
    • HCI Element cluster upgrade failed with network error
      https://kb.netapp.com/Legacy/NetApp_HCI/OS/HCI_Element_cluster_upgrade_failed_with_network_error
      Applies to NetApp HCI NetApp Hybrid Cloud Control Issue When performing Element upgrade from HCC a network error is received - Failed : Network error : HTTPSConnectionPool(host='MIP', port=442)