Applies to ONTAP 9.3 or earlier running on one of the following systems: AFF A220 FAS2720 FAS2750 Issue IPv4 is disabled, and only IPv6 is active for the BMC. A filer or BMC reboot is performed. The b...Applies to ONTAP 9.3 or earlier running on one of the following systems: AFF A220 FAS2720 FAS2750 Issue IPv4 is disabled, and only IPv6 is active for the BMC. A filer or BMC reboot is performed. The boot process displays the following messages and failure: IPMI:Read midplane FRU common header:failed *************************************************** This platform is not supported in this release. The system will now halt
Applies to AFF Systems ASA Systems FAS Systems Description This article describes how to reset the configuration information for the Service Processor (SP) or Baseboard Management Controller (BMC).
After the SP/BMC update is complete, the SP/BMC is automatically rebooted. ONTAP will inform you prior to rebooting the SP/BMC. Firmware update will need to reboot the SP on completion. To display the...After the SP/BMC update is complete, the SP/BMC is automatically rebooted. ONTAP will inform you prior to rebooting the SP/BMC. Firmware update will need to reboot the SP on completion. To display the SP/BMC update status, including whether an update is in progress, the update start and end time, and the completion percentage: To verify that the SP/BMC is online and running the intended version, run: The download page will provide the steps to update your SP/BMC
