Skip to main content
NetApp Knowledge Base

Unable to run remote Snap Creator commands after upgrading

  1. Last updated
    Dec 3, 2023
  2. Save as PDF
Views:
185
Visibility:
Public
Votes:
0
Category:
snap-creator-framework
Specialty:
legacy
Last Updated:
12/3/2023, 2:13:22 PM

Applies to

SnapCreator Framework 4.x

Issue

When attempting to run Pre- and Post-remote commands using the allowed_commands.config file, the commands fail with the following error: ERROR: At least one command is not allowed to be executed remotely

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.