Skip to main content
NetApp Knowledge Base

SMBR 8.2 configuration with SnapCenter

Last Updated:

Applies to

  • Single Mailbox Recovery
  • SnapCenter Server


This article provides the procedure to SMBR 8.2 configuration with SnapCenter.

According to the installation guide of SMBR 8.2, we do not need to install SMBR on the Exchange server; however, if SMBR is run on an Exchange Server that does not have an active copy of the database the restore is to be performed on, the following error displays:


To perform the work, you need to move the active database to the server from where SMBR is installed. (If possible)


Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device