Skip to main content
NetApp Knowledge Base

What are common commands used to troubleshoot OnCommand Insight McData switch data source?

  1. Last updated
  2. Save as PDF
Views:
224
Visibility:
Public
Votes:
0
Category:
oncommand-insight
Specialty:
ds_dii
Last Updated:

Applies to

  • OnCommand Insight
  • McData Switch  data source

Answer

Common McData switch commands used to troubleshoot OnCommand Insight connectivity to this switch data source

  • Run the below commands via PuTTY/SSH session, from the Oncommand Insight acquisition unit
Command Expected Command Function
config switch <param>value Configure switch parameters
config switch show Display show configuration
configu port <param> Configure port parameters
show all Data collection command
show fabric topology/principal Displays topology
show port info Displays port information
show system Displays system attributes
show switch Displays switch attributes
show zoning Displays fabric zoning information
mcdata_info Host based tool provided by NetApp


 

Additional Information

OnCommand Insight: What are the Fibre Channel Switch commands for troubleshooting switches?

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.