Skip to main content
NetApp Knowledge Base

ISCSI paths missing on Linux host

Views:
9
Visibility:
Internal
Votes:
0
Category:
not set
Specialty:
not set
Last Updated:

Applies to

  • * ONTAP 9.x
  • * Linux
  • * Iscsi protocol

Issue

Some of LUN???s are showing only 2 x path, normally showing 4 x path from Linux end.

??? See below difference 2 or 4 path on the same host
Host: SESKALENTOVPD01
2 path
|-+- policy='service-time 0' prio=50 status=active
| `- 2:0:0:47 sdao 66:128 active ready running
`-+- policy='service-time 0' prio=10 status=enabled
`- 9:0:0:47 sdcn 69:176 active ready running
4 path
|-+- policy='service-time 0' prio=50 status=active
| `- 7:0:0:17 sdcw 70:64 active ready running
`-+- policy='service-time 0' prio=10 status=enabled
|- 4:0:0:17 sdy 65:128 active ready running
|- 6:0:0:17 sdbf 67:144 active ready running
`- 5:0:0:17 sdcl 69:144 active ready running

Host: SESKALCOMDBPD01
2 path
|-+- policy='service-time 0' prio=50 status=active
| `- 3:0:0:18 sdaj 66:48 active ready running
`-+- policy='service-time 0' prio=10 status=enabled
`- 7:0:0:18 sdl 8:176 active ready running
4 path
|-+- policy='service-time 0' prio=50 status=active
| `- 6:0:0:2 sdg 8:96 active ready running
`-+- policy='service-time 0' prio=10 status=enabled
|- 5:0:0:2 sdb 8:16 active ready running
|- 2:0:0:2 sdak 66:64 active ready running
`- 9:0:0:2 sdaz 67:48 active ready running

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

This is an internal KB article and its content should not be copy/pasted and shared with people outside of NetApp. Always seek Duty Manager authentication of caller for password reset requests. If you need further assistance post a question in Knowledge Xchange