Skip to main content
NetApp Knowledge Base

FC adapter shows Link disconnected

Views:
31
Visibility:
Internal
Votes:
0
Category:
not set
Specialty:
not set
Last Updated:

Applies to

  • * ONTAP
  • * Brocade

Issue

Storage FC adapter shows Link disconnected 

 

network fcp adapter show –instance

 

CHECLUND01   0c       false       0       up       link not connected

CHECLUND01   0d       false       0       up       link not connected

CHECLUND01   0e       true        10000   up       online

CHECLUND01   0f       true        0       up       link disconnected

CHECLUND02   0c       false       0       up       link not connected

CHECLUND02   0d       false       0       up       link not connected

CHECLUND02   0e       true        0       up       link disconnected

CHECLUND02   0f       true        10400   up       online

 

 

       slot 0: Fibre Channel Target Host Adapter 0f

 

                (QLogic 8324 (8362) rev. 2, <LINK DISCONNECTED>)

                Firmware rev:      8.9.0

                Flash rev:         7.0.3

                Host Port Addr:    000000

                FC Nodename:       50:0a:09:80:80:d4:40:4d (500a098080d4404d)

                FC Portname:       50:0a:09:82:80:d4:40:4d (500a098280d4404d)

                Connection:        No link

                Switch Port:       Unknown

 

 

        slot 0: Fibre Channel Target Host Adapter 0e

                (QLogic 8324 (8362) rev. 2, <LINK DISCONNECTED>)

                Firmware rev:      8.9.0

                Flash rev:         7.0.3

                Host Port Addr:    000000

                FC Nodename:       50:0a:09:80:80:64:40:5b (500a09808064405b)

                FC Portname:       50:0a:09:81:80:64:40:5b (500a09818064405b)

                Connection:        No link

                Switch Port:       Unknown

 

>> Rx and Tx of ports is 0.0 uwatts

 

While enabling the switch's ports, an error message appears stating that "port cannot be enabled as the switch is disabled."

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

This is an internal KB article and its content should not be copy/pasted and shared with people outside of NetApp. Always seek Duty Manager authentication of caller for password reset requests. If you need further assistance post a question in Knowledge Xchange