Skip to main content
NetApp Knowledge Base

Is "node.session.scan = manual" in iscsid.conf required for Trident?

  1. Last updated
  2. Save as PDF
Views:
6
Visibility:
Public
Votes:
0
Category:
trident-kubernetes
Specialty:
snapx
Last Updated:

Applies to

  • Trident
  • Trident SAN CSI drivers (ontap-san, ontap-san-economy, solidfire-san)

Answer

Yes. node.session.scan = manual in /etc/iscsi/iscsid.conf must be set to avoid conflicts, as Trident automatically performs LUN scanning.

Note: Do not perform manual LUN scanning unless specifically instructed by NetApp.

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.