Skip to main content
NetApp Knowledge Base

Switch port in persistently Disabled state due to duplicate WWPN errors on Brocade switch

  1. Last updated
  2. Save as PDF
Views:
661
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

Brocade Switch

Issue

  • A port is persistently disabled when FLOGI request with duplicate WWPN is received.
  • In the error dump, the FCPH-1003 message is recorded as shown below:

2022/03/16-17:56:47, [FCPH-1003], 638281, SLOT 2 | FID 128, WARNING, FAB2, Logging out new port 10/20 with same Port WWN [50:05:07:60:44:5c:af:0a] as old port 11/20[pid:68e440] due to duplicate Port WWN detection policy.
2022/03/16-17:56:54, [FCPH-1003], 638282, SLOT 2 | FID 128, WARNING, FAB2, Logging out new port 11/21 with same Port WWN [50:05:07:60:44:5c:af:0b] as old port 12/20[pid:68f440] due to duplicate Port WWN detection policy.
2022/03/16-17:56:58, [FCPH-1003], 638283, SLOT 2 | FID 128, WARNING, FAB2, Logging out new port 10/19 with same Port WWN [50:05:07:60:44:5c:af:09] as old port 10/18[pid:68d240] due to duplicate Port WWN detection policy.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.