Skip to main content
NetApp Knowledge Base

nblade.execsOverLimit in EMS - Resolution Guide

  1. Last updated
  2. Save as PDF
Views:
43,458
Visibility:
Public
Votes:
26
Category:
ontap-9
Specialty:
nas
Last Updated:

Applies to

  • ONTAP 9.8 and later
  • Kubernetes cluster
  • NetApp Astra Trident
  • NFSv3
  • NFSv4.x

Issue

  • EMS:

kernel: nblade.execsOverLimit:error]: The number of in-flight requests from client with source IP 10.20.30.40 to destination LIF 10.20.30.50 (Vserver 7) is greater than the maximum number of in-flight requests allowed (128). The client might see degraded performance due to request throttling.

Note: This message has been moved to severity notice in newer patch releases. This reflects that fact that this message may not always be a cause for concern.

  • This message is normal and expected when the Oracle dNFS client is in use. It does not indicate a problem.
  • High latency or a sudden drop in throughput during peak load on NFS clients might be observed, especially linux.
  • Performance impact cannot be attributed to a CPU/Memory/Disk bottleneck on the storage controllers via CLI or monitoring tools

Note: The message was introduced in ONTAP 9.8 but the throttling existed before ONTAP 9.8 so the same considerations apply

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.