Skip to main content
NetApp Knowledge Base

Values reported in SVMDR Total Progress field imply low throughput

  1. Last updated
  2. Save as PDF
Views:
313
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror
  • SVM DR
  • FlexGroup SnapMirror

Issue

  • An SVM DR expected to transfer a large amount of data has been running for a number of hours
  • The SVM DR Total Progress field reflects a much smaller amount of data than what was expected to transfer
  • If throughput is estimated based on Total Progress over elapsed time, estimated throughput will seem very low

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.