Skip to main content
NetApp Knowledge Base

How to enable NetApp Volume Encryption (NVE) on existing SVM-DR destination volumes

  1. Last updated
  2. Save as PDF
Views:
482
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9 and later versions
  • SVM DR
  • NetApp Volume Encryption (NVE)

Description

The procedure in this article outlines the steps needed to encrypt SVM-DR destination volumes
 
NOTE: The encryption configuration is unique to the cluster in which it was configured. If encryption wasn't enabled on the source volumes, or the destination didn't have a node that support NVE at the time of initialization, then it needs to be manually enabled on the destination volumes afterwards.
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.