Skip to main content
NetApp Knowledge Base

Error message when initializing a SnapMirror TDP destination volume as the source for a SnapMirror relationship

Views:
1,218
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
DP
Last Updated:

Applies to

  • ONTAP 9
  • Data ONTAP 8 7-Mode
  • Transition data protection (TDP) SnapMirrors
 

Issue

When attempting to initialize a SnapMirror relationship where the source volume is also a destination for an active SnapMirror type TDP (AKA transition) relationship, the following error message is reported

  • Failed to get information for source volume TDPDest_vServer:TDPDest_Vol for confirmation.(Source TDPDest_vServer:TDPDest_Vol is a transition volume) Using a transition volume as a SnapMirror source volume is not supported.
  •  [<NODE>: repl_Handle_reg: repl.src.snaps.check.failed:error]: SnapMirror operation failed because the reference and/or the transfer Snapshot copies on the source volume are either a) from a release prior to Data ONTAP 8.2 b) captured in a nonclustered format c) not upgraded to dual inode space. These Snapshot copies cannot be used for logical transfer.
     

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.