Skip to main content
NetApp Knowledge Base

Errors incrementing on Brocade switch port

  1. Last updated
  2. Save as PDF
Views:
113
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • Fabric MetroCluster
  • ONTAP 9
  • Broadcom 65xx switches

Issue

  • Errors incrementing against a single Brocade switch port

Example:

porterrshow        :
          frames      crc    crc     bad   pcs   
       tx     rx      err    g_eof   eof     err  
...  
  6:   11.0m  45.1m   346    343       3      587.4k

  • Command aborted errors are seen in the node event log

Example:

Sun May 08 09:53:38 +0200 [Node02: isp2400_intrd: scsi.cmd.abortedByHost:error]: Disk device SwitchA2:8.126L24: Command aborted by host adapter: HA status 0x4: cdb 0x9a:00000000e7a39000:0001:0200. 
Sun May 08 09:53:38 +0200 [Node02: isp2400_intrd: scsi.cmd.retrySuccess:debug]: Disk device SwitchB2:8.126L24: request successful after retry #1/#0: cdb 0x9a:00000000e7a39000:0001:0200 (10084).

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.