Skip to main content
NetApp Knowledge Base

Cannot switchover with one node unreachable

  1. Last updated
  2. Save as PDF
Views:
360
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
MetroCluster
Last Updated:

Applies to

  • ONTAP 9
  • 4 Node MetroCluster (Fabric or IP)
  • 1 node is down and in takeover

Issue

Switchover fails due to being unable to contact the node that is down

Example:

Warning: Unable to list entries on node Node1a. RPC: Couldn't make connection [from mgwd on node "Node1b" (VSID: -1) to
mgwd at XXX.XXX.XXX.XXX]
Error: command failed: Failed to retrieve system image status information for all nodes. Reason: RPC: Couldn't make connection [from
mgwd on node "Node1a" (VSID: -1) to mgwd at XXX.XXX.XXX.XXX]. Verify that the nodes are healthy using the "cluster show"
command and that cluster peering is available using the "cluster peer show" command, then retry the operation.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.