Skip to main content
NetApp Knowledge Base

Cannot set MTU for network port in ONTAP System Manager

  1. Last updated
  2. Save as PDF
Views:
644
Visibility:
Public
Votes:
1
Category:
ontap-system-manager
Specialty:
om
Last Updated:

Applies to

ONTAP System Manager 9.8 and later

Answer

  • System Manager in ONTAP 9.8 and later does not provide the ability to change the maximum transmission unit (MTU) size for a network port
  • Run the following CLI command to modify the MTU for a network port.
    Note: The port's MTU is determined by its broadcast domain. Changing the MTU value will affect all ports in the broadcast domain:

network port broadcast-domain modify -ipspace <IPspace> -broadcast-domain <broadcast-domain> -mtu <new_value>

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.