Skip to main content
NetApp Knowledge Base

mNode on Element 11.x shows an IPv6 default gateway present when none was configured

  1. Last updated
  2. Save as PDF
Views:
163
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
hci
Last Updated:

Applies to

  • NetApp Element 11.x
  • Management node (mNode) 

Issue

  • IPv6 gateway address automatically populated and not able to remove
  • Following error is returned when configuring static IP address in mNode TUI
Malformed network configuration on eth0: IPv6 Address and Gateway must both be specified or neither specified in static mode

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device