Skip to main content
NetApp Knowledge Base

Vol Expand successful but the size of the volume has not finished updating

Last Updated:

Applies to




When trying to expand volume flexgroup you receive the following error

Warning: The following
number of constituents of size xxTB will be added to
FlexGroup "flexgroup name": 4. Expanding the FlexGroup will cause the
state of all Snapshot copies to be set to "partial". Partial Snapshot copies
cannot be restored.
Do you want to
continue? {y|n}: y
[Job xxxx] Steps completed: 8 of 9.
Error: command failed: [Job xxxx] Job failed: The volume operation was
successful but the size of the volume has not finished updating. Wait a
few minutes, and then check that the size of the volume is "xxTB" using
the "volume show -vserver "vserver" -volume "volume" -fields size" command.
For further assistance, contact technical support.


Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device