Skip to main content
NetApp Knowledge Base

Can capacity balance policy be configured in FlexGroup Volume Constituent?

  1. Last updated
  2. Save as PDF
Views:
232
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • FlexGroup

Answer

No.

After converting a Flexvol to a FlexGroup and adding new member volumes, the FlexGroup should automatically be placing most new content onto the new member volumes. And if the original volume was very close to full, the FlexGroup should be placing very little new content on it at all. There should be no need for an explicit setting to force this behavior.

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.