Skip to main content
NetApp Knowledge Base

MetroCluster reports "Node is of a different model than other nodes in same DR group" after recabling or mainboard/nvram replacement

Views:
138
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster
  • ONTAP 9

Issue

After recabling or replacement of a mainboard/nvram in a 4 or 8 node MetroCluster, the following error is seen when executing metrocluster configure -refresh true.

Job failed: Node is of a different model than other nodes in same DR group

MetroCluster configuration requires all nodes in DR group to be of the same model. 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device