Skip to main content
NetApp Knowledge Base

Key Manager prevents MetroCluster expansion from four to eight nodes

  1. Last updated
  2. Save as PDF
Views:
146
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster
  • OnBoard Key Manager

Issue

Key Manager does not allow Configuration during a node Expansion.

Error message:
ClusterA::*> metrocluster configure -node-name MCCNODE1

Error: command failed: MetroCluster cannot be configured while keymanager is configured on both partner
       sites. Disable keymanager on one of the partner sites and then proceed with MetroCluster
 configuration. After successfully configuring MetroCluster, configure key manager on the partner
       site where it was disabled. If using onboard key manager, run the "security key-manager onboard
       sync" command on the partner site. Otherwise, if using external key manager, run the "security
       key-manager external enable" command on the partner site.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device