Skip to main content
NetApp Knowledge Base

Failed to add Brocade Switch with RCF version 9.3 to health monitoring

Views:
615
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster
  • RCF 9.3
  • Brocade G610

Issue

When trying to add a switch to health monitoring the following error occurs

ClusterA::> storage switch add -address 10.10.10.10

Error: command failed: Internal error. Failed to add switch for monitoring on node "ClusterA-01" in cluster "ClusterA". Reason: Failed to check if device located at "10.10.10.10" is from supported vendor. For further assistance, contact technical support.
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.